1.How to install the driver?
A. Please insert the floppy into your PC and open it.

B. Or you can download the driver from our website directly.

C. Running the “Superjoy.exe” setup program.

D. After running the setup program, you will see those dialog boxes as below shows.
Click “next” to continue the setup program, you can finish the installation.

E. Finally, press the “Finish” button to exit this installation.

2.How to connect and test it?

A. Please connect your controller with our Productss first, and then plug our Products into the USB port of your PC.

B. Then go into “My Computer”→“Control Panel”→“Game Controller”, you will see those dialog boxes as below shows:

C. Select the controller which shows in control Box, and then click “Properties” button, you will be go
into the testing interface.

D.This page is special for testing the function of the controller button:

a. When you press the function button, the relevant number will be lighted on the “Button” area.

b. Also the “+” mark will be moved on the blank frame when you press the direction key.

c. The LED will be light while you press the ‘Analog’ button.

d. The red spot in the “Hat Switch” box will remove while you press the direct key again.

e. Shake the left axis and right axis separately, the relevant “+” mark will remove with the frequent shaking.

3. How to calibrate it?

A. Click “calibrate” button to begin the calibration as clue, finish and exit. Then press the “Properties”
button on the page of “game controller” to test effects of calibrate. If it is fail to calibration, you can click “Reset”
button to revert to original states.

B. Change the page to “Force Feedback”, and then you can begin to test vibration.

a. Press “left” button on the “Force Test” box, the left motor of controller will be vibrated, you can got
the effects time from the show bars.

b. Press “right” button on the “Force Test” box, the right motor of controller will be vibrated, you can got
the effects time from the show bars.

c. Press “Dual” button on the “Force Test” box, then two motors of controller will be vibrated, you can got
the effects time from the show bars.

Finally, press the “Finish” button to exit testing and calibration, then you can start the game.