1. Compatible with more original or third party controllers and arcade stick as below.
|PS3 Navigation Controller||CECH-ZCS1U||YES||YES|
|GuliKit KingKong 2 Pro Controller||NS09||YES|
(6-axis Motion Control is not supported )
|ipega SW001 Wireless Controller||PG-SW001||YES||YES|
|Flydigi Direwolf Wireless Gaming Controller||Direwolf||YES||BT & 2.4G|
|Razer Atrox Arcade Stick For Xbox One||RZ06-0115||YES||NO|
2. T-pad supported perfectly while connect PS DualSense controller to Magic-S Pro 2 /Magic-S Ultimate on PlayStation 4 system
Download the software from https://www.mayflash.com/Support and install it on your Windows system.
Double click on the updater and leave the updater window open on your screen.
Press and hold the button on the side of the adapter, and connect the USB from your adapter in o any spare port on your PC.
As soon as the driver window indicates under “Device” that the adapter has been recognized, you may release the button.
Do not disconnect the device until you are informed that the updated was completed successfully.
The update process is slow, please be patient. If there are any errors in the update process, please try it again.
If you are having the issues connecting a Xbox Series S/X controller to the MAGIC-NS 2 for using with a Nintendo Switch, please disable or turn off any Bluetooth device (like your Smart TV or Set Top Box etc.) within range of the controller, and sync the controller and adapter again.
Switch Pro mode (the LED indicator is purple)
To make sure the system can identify the adapter easily, please turn on the “Pro Controller Wired Communication” of the Nintendo Switch system.
once you switch the adapter to the Switch Pro mode (the LED indicator is purple) .
Tips: System Settings - Controllers and Sensors - Pro Controller Wired Communication – ON.
Download the firmware from https://www.mayflash.com/Support and install it on your Windows system.
Press and hold the button on the side of the adapter, and connect the USB from your adapter in o any spare port on your PC, and wait for 3-5 seconds. After completing the above steps, the program automatically identifies the adapter (LED indicator turns off).
Click "update" and wait for a few seconds. The update is completed when the progress bar reaches 100%.
Note: Do not disconnect the device until you are informed that the updated was completed successfully
Press "OK" to complete the update.