Magic-NS Rev2.0 Wireless Controller Adapter M:V1.04 S:V1.30: Compatible with Google Stadia controller and Adjust the vibration intensity

2023-03-20 11:27:13
Product :
Magic-NS Rev2.0 USB Wireless Adapter
Item No. :
MAGIC-NS
Version No :
M:V1.04 S:V1.30
File Type :
Download

V1.04(V1.30)


Compatible with Google Stadia controller

--Please re-plug the Stadia controller to Magic adapter once it disconnected of not use for several minutes in wired connection


Compatible with Razer Raiju Ultimate controller

--Switch to PC/BT mode for the controller, 6-axis motion control and rumble are not supported.


Supports R1&L1 remapping

--R1=L1, L1=R1 by pressing and holding Start+R1 for 3 seconds.

--Reset to default L1=L1, R1=R1 by pressing and holding Start+L1 for 3 seconds

 

Change the vibration intensity level from 7 levels to 10

(0%  25%  37.5%  50%  62.5%  75%  87.5%  100%  125%  150%, The default vibration intensity is 100%.)

 

Adjust the vibration intensity

Quick Start:

  1. Pressing and holding the two buttons R1/RB and R3 for 3-5 seconds until the controller keeps rumbling.

    (Note: You need to keep holding these two buttons until you finish the whole process)

  2. To adjust the vibration intensity, press the Directional Pad "Up" or "Down".

  3. To quit the vibration adjusting, release any button of R1/RB or R3 once you have got your preferred vibration intensity.

    (Note: No vibration on the Nintendo Switch System mode/LED in red. The vibration is compatible with PS3 Game Console on the PS3 or PC Dinput System mode/LED in blue)


Quick Start

  1. Download the software from https://www.mayflash.com/Support and install it on your Windows system.

  2. Double click on the updater and leave the updater window open on your screen.

  3. Press and hold the button on the side of the adapter, and connect the USB from your adapter in o any spare port on your PC.

  4. As soon as the driver window indicates under “Device” that the adapter has been recognized, you may release the button.

  5. select “update”.

  6. Do not disconnect the device until you are informed that the updated was completed successfully.



Switch Pro mode (the LED indicator is purple)

To make sure the system can identify the adapter easily, please turn on the “Pro Controller Wired Communication” of the Nintendo Switch system.

once you switch the adapter to the Switch Pro mode (the LED indicator is purple) .

Tips: System Settings - Controllers and Sensors - Pro Controller Wired Communication – ON.

MAYFLASH Limited



More Instructions

  1. Download the firmware from https://www.mayflash.com/Support and install it on your Windows system.

    MAYFLASH Limited

  2. Press and hold the button on the side of the adapter, and connect the USB from your adapter in o any spare port on your PC, and wait for 3-5 seconds. After completing the above steps, the program automatically identifies the adapter (LED indicator turns off).

    MAYFLASH Limited

  3. Click "update" and wait for a few seconds. The update is completed when the progress bar reaches 100%.

    Note: Do not disconnect the device until you are informed that the updated was completed successfully

    MAYFLASH Limited

  4. Press "OK" to complete the update.

MAYFLASH Limited